3D printing

Objective of this pratical: 1. Design the object by using 3D printer 2. Using Cura to adjust the settings before printing. 3. Operate the 3D printer. At the end of this practical, I should be able to: 1. More famaliar with Fusion 360 2. Choose more suitable parameters in Cura before printing. 3. Observe how 3D Printer works.

To begin, create a sphere..

Cut the sphere horozontally by spiting them in to two.

Now the sphere becomes to seperate body.

Move the sphere horizontally and delete the upper body.

Draw a line in the middle of the half sphere.

Extrude half of the sphere.

Create a new sketch and using arc to draw a half circle.

Finish the sketch and extrude the half circle to desired height.

Adjust the body in to the roboy by moving it horizontally and vertically.

Create a new sketch by drwaing two circle at the bottom. The size of the circle will be the thickness of the robot's leg

Extrude the circles. The height will be the length of the leg.

Create a new sketch by drawing two circles at two sides of the body. The size will be the thichness of the arm.

Extrude the two circles to the height desired to reach the length of the arm.

Create two sphere and size of the spheree will be the size of the eye ball.

Arrange the eye balls in all three perspectives or three dimentions to fit into the correct position on the robot.

This will be the final view of the robot on Fusion 360.

This will be the final pring by using 3D printer!